Hirschmann HiSecOS EAGLE30 - Page 268

WAN > SHDSL/EFM > Configuration
WAN
268
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
Operation mode Specifies the operating mode that the device applies to the pair.
Change the operating mode only if no connection through the port has been
established. For the 2 pairs of a port, always use the same operating mode.
Possible values:
 ieee2BaseTLO
Operating mode “Office”
 ieee2BaseTLR
Operating mode “Remote”
Profile Specifies the profile that the device applies to the pair.
Possible values:
 -none-
No profile assigned.
 efmCuPme2BProfile[1..20]
The profile contains settings including the data rate, annex, and
modulation type; see the following table.
When you position the mouse pointer over one of the values, a bubble help
displays the most important settings saved in the profile.
Profile Min data
rate (kbit/s)
Max data
rate (kbit/s)
Power
(dBm)
Region Constellation Standard/
Custom
1 5696 5696 13.5 North America
(Annex A sec. A.4.1)
32-TCPAM Standard
2 3072 3072 13.5 North America
(Annex A sec. A.4.1)
32-TCPAM Standard
3 2048 2048 13.5 North America
(Annex A sec. A.4.1)
16-TCPAM Standard
4 1024 1024 13.5 North America
(Annex A sec. A.4.1)
16-TCPAM Standard
5 704 704 13.5 North America
(Annex A sec. A.4.1)
16-TCPAM Standard
6 512 512 13.5 North America
(Annex A sec. A.4.1)
16-TCPAM Standard
7 5696 5696 14.5 Europe
(Annex B sec. A.4.1)
32-TCPAM Standard
Table 5: Profiles with settings
Parameters Meaning
Office RemoteRemote
ieee2BaseTL O ieee2BaseTL R
ieee2BaseTL O ieee2BaseTL R