WAN > SHDSL/EFM > Statistics
WAN
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
273
Fault Status Displays the possible cause for connection errors on the pair. If the device
does not detect a connection error, the field remains empty.
Possible values:
lossOfFraming
Loss of synchronisation.
snrMgnDefect
The signal-to-noise ratio falls below the threshold.
lineAtnDefect
The line attenuation exceeds the threshold.
deviceFault
The device has detected a self-test error.
configInitFailure
Initialization error. The connection on the pair does not support the
requested profile.
protocolInitFailure
Initialization error. The remote device is using an incompatible protocol.
Operation mode Displays the operating mode that the device applies to the pair.
Possible values:
ieee2BaseTLO
Operating mode “Office”
ieee2BaseTLR
Operating mode “Remote”
Oper Profile Displays the SHDSL profile that the device applies to the pair.
Possible values:
0
No connection has been established.
or
The connection is being initialized.
efmCuPme2BProfile[1..14]
The profile contains the modem settings, including the data rate, annex,
and modulation type.
SNR [dB] Displays the current signal-to-noise ratio in dB on the pair (determined by
the local device).
Possible values:
-127..128
65535
No connection has been established.
or
The connection is being initialized.
SNR Remote [dB] Currently the device does not support this function.
Possible values:
65535
Parameters Meaning
To Next Page
Loading...