Routing > Interfaces > Configuration
Routing
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
281
Routing Activates/deactivates the "Routing" function on the router interface.
In the process, the device removes the state information from the packet
filter. This includes potential DCE RPC information of the OPC enforcer. In
the process, the device interrupts open communication connections.
Possible values:
marked
The "Routing" function is active.
– With port-based routing, the device transforms the port into a router
interface.
Enabling the "Routing" function removes the port from the VLANs in
which it was previously a member. Disabling the "Routing" function
does NOT reestablish the assignment; the port is not a member of
any VLAN.
– With VLAN-based routing, the device forwards the data packets in
the corresponding VLAN.
unmarked
(default setting)
The "Routing" function is inactive.
With VLAN-based routing, the device is still reachable through the
router interface if the IP address and network mask have been
configured for the router interface.
Proxy ARP Activates/deactivates the Proxy ARP function for the router interface. This
feature allows you to connect devices from other networks as if these
devices could be reached in the same network.
Possible values:
marked
Proxy ARP function is active.
The device responds to ARP requests from end devices that are located
in other networks.
unmarked
(default setting)
Proxy ARP function is inactive.
MTU Value Specifies the maximum allowed size of IP packets on the router interface in
bytes.
Possible values:
0
Restores the default value (
1500
).
68..1500
(default setting:
1500
)
The prerequisite is that on the ports belonging to the router interface you
specify the maximum allowed size of Ethernet packets at least 18 bytes
larger than specified here. See the
Basic Settings > Port
dialog,
"MTU" field.
Parameters Meaning
To Next Page
Loading...