Routing > Interfaces > Configuration
Routing
284
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
Setup virtual routerport
Parameters Meaning
Port Displays the port number.
Member Activates/deactivates the VLAN membership of the port.
As a VLAN member the port belongs to router interface to be set up. This
setting overwrites the setting for the port specified in the
Switching >
VLAN
> Configuration
dialog.
Possible values:
marked
The port is a member of the VLAN.
unmarked
The port is not a member of the VLAN.
Untagged Activates/deactivates the transmission of data packets with a VLAN tag on
the port. This setting overwrites the setting for the port specified in the
Switching > VLAN > Configuration
dialog.
Possible values:
marked
The port transmits the data packets without a VLAN tag.
Use this setting if the connected device does not evaluate any VLAN
tags, for example on end device ports.
unmarked
The port transmits the data packets with a VLAN tag.
Port VLAN ID Specifies the ID of the VLAN which the devices assigns to data packets
without a VLAN tag. This setting overwrites the setting for the port
specified in the
Switching > VLAN > Port
dialog, field "Port-VLAN ID".
Possible values:
ID of a VLAN you set up (default setting:
1
)
Parameters Meaning
Primary Address
Address Specifies the primary IP address for the router interface.
Possible values:
Valid IPv4 address (default setting:
0.0.0.0
)
Netmask Specifies the primary netmask for the router interface.
Possible values:
Valid IPv4 netmask (default setting:
0.0.0.0
)
To Next Page
Loading...