Routing > Interfaces > Configuration
Routing
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
285
When you assign ports to the router interface that already transmit data
packets in other VLANs, the device displays a message upon closing the
Wizard:
When you click "Yes", the corresponding ports transmit the data
packets from now on in the router VLAN exclusively.
In the
Switching > VLAN > Configuration
dialog, the corresponding
ports in the row of the router VLAN have the value
U
or
T
, in the rows
of other VLANs the value
–
.
When you click "No", the corresponding ports transmit the data
packets in the router VLAN and in other VLANs.. This setting possibly
causes undesired behavior.
After closing the Wizard, click the "Set" button to save your settings.
Buttons
Parameters Meaning
Secondary Addresses
Address Specifies a further IP address for the router interface (Multinetting).
Possible values:
Valid IPv4 address (default setting:
0.0.0.0
)
Specify an IP address which differs from the primary IP address of the
router interface.
The device allows you to specify up to 2 IP addresses (1 primary,
1 furthers) for a router interface and a total of up to 64 IP addresses.
Netmask Specifies the netmask for the belonging further IP address.
Possible values:
Valid IPv4 netmask (default setting:
0.0.0.0
)
Button Meaning
Add Adds the values entered in the fields "Address" and "Netmask" to the list
for other addresses. The device uses the IP addresses from this list for
multinetting.
Remove Removes the highlighted entry from the "Secondary Addresses" list.
Back Displays the previous page again. Changes are lost.
Next Saves the changes and opens the next page.
Finish Saves the changes and closes the wizard.
Cancel Closes the Wizard. Changes are lost.
To Next Page
Loading...