Routing > NAT > 1:1 NAT > Rule
Routing
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
383
Destination
Address
Specifies the destination address of the data packets to which the device
applies the NAT rule. The device sends data packets with this destination
address to the destination address specified in the "New Destination
Address" field.
Possible values:
Valid IPv4 address
The device applies the NAT rule exclusively to data packets
containing the destination address specified here.
Valid IPv4 address and netmask in CIDR notation
The device applies the NAT rule exclusively to data packets
containing a destination address in the subnet specified here.
Egress Interface Assigns the NAT rule to the router interface on which the device sends the
modified data packets. The destination device can actually be reached in
the network connected here.
Possible values:
<Interface number>
The device sends the modified data packets on this router interface.
no Port
No router interface is assigned to the NAT rule. Someone removed the
router interface after the last edit of the NAT rule.
New Destination
Address
Specifies the actual IP address of the destination device. The device
sends data packets to the destination address specified here.
Possible values:
Valid IPv4 address
The device replaces the destination address in the data packet with
this new destination address.
Valid IPv4 address and netmask in CIDR notation
The device replaces the destination address in the data packet with a
destination address in the subnet specified here.
Trap Activates/deactivates the sending of SNMP traps when the rule is applied
to data packets.
Possible values:
marked
The device sends an SNMP trap when it applies the rule to a data
packet.
unmarked
(default setting)
The sending of SNMP traps is deactivated.
The prerequisite for sending SNMP traps is that you enable the function in
the
Diagnostics > Status Configuration > Alarms (Traps)
dialog and
specify at least 1 SNMP manager.
Parameters Meaning
To Next Page
Loading...