Routing > NAT > 1:1 NAT > Rule
Routing
384
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
Buttons
Log Activates/deactivates the logging in the log file (system log).
Possible values:
marked
Logging is activated.
The device places an entry in the log file (system log) when it applies
the rule to a data packet.
unmarked
(default setting)
Logging is deactivated.
Active Activates/deactivates the NAT rule.
Possible values:
marked
The NAT rule is active.
unmarked
(default setting)
The NAT rule is inactive.
To apply the changes to the data stream, click in the
Routing > NAT > NAT
Global
dialog the "Commit Changes" button.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM
) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
Open the
Basic Settings > Load/Save
dialog.
In the table, highlight the desired configuration profile.
If in the "Selected" column the checkbox is
unmarked
, click the
"Select" button.
Click the "Save" button.
Set and back Transfers the changes to the volatile memory (
RAM
) of the device and goes
back to the previous dialog.
Back Displays the previous dialog again. Changes are lost.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM
) of the device.
Create Adds a new table entry.
Remove Removes the highlighted table entry.
Help Opens the online help.
Parameters Meaning
To Next Page
Loading...