Routing > NAT > Destination NAT > Rule
Routing
390
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
Destination Port Specifies the destination port of the data packets to which the device
applies the rule.
Possible values:
any
(default setting)
The device applies the rule to every data packet without considering
the destination port.
1..65535
The device applies the rule exclusively to data packets containing the
specified destination port.
The field allows you to enter the following options:
– You specify a port with a single numerical value, e.g.
21
.
– You specify multiple individual ports with numerical values
separated by commas, e.g.
21,80,110
.
– You specify a port range with numerical values connected by
dashes, e.g.
2000-3000
.
– You can also combine ports and port ranges, e.g.
21,2000-
3000,65535
.
The field allows you to specify up to 15 numerical values. If you
enter
21,2000-3000,65535
, for example, you use 4 of 15
numerical values.
New Destination
Address
Specifies the actual IP address of the destination device. The device
sends data packets to the destination address specified here.
Possible values:
Valid IPv4 address
The device replaces the destination address in the data packet with
this new destination address.
New Destination
Port
Specifies the port of destination device. The device sends data packets to
the destination port specified here.
Possible values:
any
The device retains the original destination port in the data packet.
1..65535
The device replaces the destination port in the packet with this new
destination port.
Parameters Meaning
To Next Page
Loading...