Routing > NAT > Destination NAT > Rule
Routing
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
391
Protocol Restricts the NAT rule to an IP protocol. The device applies the NAT rule
exclusively to packets of the specified IP protocol.
Possible values:
icmp
Internet Control Message Protocol (RFC 792)
igmp
Internet Group Management Protocol
ipip
IP in IP tunneling (RFC 1853)
tcp
Transmission Control Protocol (RFC 793)
udp
User Datagram Protocol (RFC 768)
esp
IPsec Encapsulated Security Payload (RFC 2406)
ah
IPsec Authentication Header (RFC 2402)
icmpv6
Internet Control Message Protocol for IPv6
any
(default setting)
The device applies the NAT rule to every data packet without
considering the IP protocol.
Log Activates/deactivates the logging in the log file (system log).
Possible values:
marked
Logging is activated.
The device places an entry in the log file (system log) when it applies
the rule to a data packet.
unmarked
(default setting)
Logging is deactivated.
Parameters Meaning
To Next Page
Loading...