Basic Settings > Load/Save
Basic Settings
50
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
Buttons
Fingerprint Displays the checksum saved in the configuration profile.
The device calculates the checksum when saving the settings and inserts
it into the configuration profile.
Fingerprint Verified Displays whether the checksum saved in the configuration profile is valid.
The device calculates the checksum of the configuration profile marked as
“Selected” and compares it with the checksum saved in this configuration
profile.
Possible values:
marked
The calculated and the saved checksum match.
The saved settings are consistent.
unmarked
For the configuration profile marked as “Selected” applies:
The calculated and the saved checksum are different.
The configuration profile contains modified settings.
Possible causes:
– The file is damaged.
– The file system on the external memory is inconsistent.
– A user has exported the configuration profile and changed the
XML file outside the device.
For the other configuration profiles applies: The device has not
calculated the checksum.
The device verifies the checksum correctly only if the configuration profile
has been saved before as follows:
– on an identical device
– with the same software version, which the device is running
Note: This function identifies changes to the settings in the configuration
profile. The function does not provide protection against operating the
device with modified settings.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM
) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
Open the
Basic Settings > Load/Save
dialog.
In the table, highlight the desired configuration profile.
If in the "Selected" column the checkbox is
unmarked
, click the
"Select" button.
Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM
) of the device.
Parameters Meaning
To Next Page
Loading...