16. Enter < boot entry number >.
< Boot entry number >: The status was indicated as Used before
replacing the failed card.
17. Enter < Number >.
< Number >: The two digits which indicated the same DID or WWPN
before replacing the failed card.
18. Enter < LUN> which you record before replacing.
19. Find < LUN > which you entered in step 11, and then enter the
corresponding < Two digits number >.
20. Enter < Number >.
< Number >:
1. When WWPN was only registered before replacing the failed card.
2. When DID was only registered before replacing the failed card.
7-22
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
