21. Confirm the registered boot entry.
22. Repeat Step 16 to Step 21 for each entry, which status was indicated as
Used, if multiple boot entries are registered.
23. Press Esc several times until the following window is displayed.
24. Enter < another number > for the second port, and then press Enter key.
< another number > : 2 or 4
25. Repeat step 8 to step 23 to setup second port.
26. Power off the server blade.
Restoring parameter of FC mezzanine card when BIOS version is 2.12a13
1. The BIOS utility is displayed. Select < number > and then press Enter
key.
< number > : 1 or 3 the first port number of the failed card
Configuring Emulex mezzanine card
7-23
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
