Note: When two Emulex FC mezzanine cards are installed in mezzanine
slot #2 and #4, the first port of the mezzanine card in slot #4 is indicated
in number 3 line.
2. Confirm and record Port Name and Node name.
3. Select Enable/Disable Boot from SAN, and then press Enter.
4. Select Enable or Disable corresponding to the recorded setting before
the replacement, and then press Enter.
Press Esc to return to the previous window.
7-24
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
