Note: When the server blade has not been rebooted since the firmware
version of management module had been updated to A0145 or later, No
history is indicated.
8. Depending on the server model and firmware versions, select one of the
following procedures.
a. The server model is CB 520H B3/B4, CB 520X B1/B2/B3:
End of the procedure before the replacement. Perform the
replacement.
b. The server model is CB 520H B2:
Go to
Preparing to confirm the FCoE settings on page 7-64.
c. The server model is CB 520H A1/B1, CB 520A A1, CB 540A A1/B1, the
management module firmware version is A0180 or later:
Server model Firmware version
CB 520H A1/B1 01-70 or later
CB 520A A1 02-38 or later
CB 540A A1/B1 03-20 or later
Go to Confirming the UMC and Personality settings on page 7-63.
d. The server model is CB 520H A1/B1, CB 520A A1, CB 540A A1/B1, the
management module firmware version is A0179 or earlier:
When the server blade is CB 520H B2, confirming the iSCSI setting is
not required.
Server model Firmware version
CB 520H A1/B1 01-69 or earlier
CB 520A A1 02-37 or earlier
CB 540A A1/B1 03-19 or earlier
7-56
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
