4. Press ESC. The window in step 3 is displayed again.
Move cursor onto Configure Boot Devices by using ↑ and ↓, and then
press Enter.
Confirm and write down the values of DID, WWPN, and LUN for each
lines indicated as Used in List of Saved Boot Devices window.
(Skip this step when the BIOS setting for the first port is set to
Disabled.)
5. Press ESC. The window in step 3 is displayed again.
Move cursor onto Configure DCBX mode by using ↑ and ↓, and then
press Enter.
Confirm and write down the DCBX mode is line.
(Skip this step when the BIOS setting for the first port is set to
Disabled.)
7-68
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
