6. Press ESC. The window in step 3 is displayed again.
Move cursor onto Configure FCF CIN Parameters by using ↑ and ↓, and
then press Enter.
Move cursor onto Enable/Disable VLAN ID by using ↑ and ↓, and then
press Enter.
Confirm and write down The current VLAN ID is line.
(Skip this step when the BIOS setting for the first port is set to Disabled
or DCBX mode is CEE.)
7. Press ESC. The window in step 3 is displayed again.
Move cursor onto Configure Advanced Adapter Parameters by using ↑
and ↓, and then press Enter.
8. Move cursor onto Change Default ALPA of this Adapter by using ↑ and
↓, and then press Enter.
Confirm and write down The Adapter ALPA is line.
9. Repeat the step 8 above by moving cursor onto Change PLOGI Retry
Timer, Enable or Disable Spinup Delay, Auto Scan Setting, Enable
or Disable EDD 3.0, Enable or Disable Start Unit Command, Enable
Configuring Emulex mezzanine card
7-69
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
