No. Server model
# of CNA
1
# of CTRL
2
Controller #
4. The controller #0 and #1 are assigned to LOMs for CB 540A B1 (GGAGD0Bn-
with LOM).
Note: The Controller Selection Menu above is not displayed when none
of Emulex 10Gb CNA mezzanine card and LAN mezzanine card is installed
on CB 520H B1/B2 (with LOM model).
Note: The Personality for Emulex 10Gb LAN mezzanine card and LOM is
fixed to NIC.
9. Press Enter several times until Controller Selection Menu is displayed.
10. Select the second controller, and then repeat from step 7 to step 8.
11. When you are prompted continue?, press Y.
Press Esc several times until Do you want to exit from the utility
[Y/N]? is prompted, and then press Y.
12. Wait about five minutes until System Configuration and Boot
management window is displayed.
13. Press Esc in System Configuration and Boot Management window.
When the Do you want to exit … dialog box is displayed, press Y.
Configuring Emulex mezzanine card
7-93
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
