Adjustment of the setting temperature range of the remote control switch
1 Select “Setting temp. range of the remote control” at the “Menu” screen.*
* Selection is not possible in case that the connected air conditioners do not support this function.
(1)
2 Select the target for setting of temperature range. (All Groups/Block/Group)*
• The buttons of the groups with temperature range settings are shown in blue.
• The buttons of the groups in which temperature range setting is not available are shown in grey.
• The buttons of the groups with no temperature range settings remain inactive.
• Do not apply settings in groups using a wireless receive kit (PC-ALH3), since it is possible to set temperatures out-
side of the setting range from a wireless remote control switch.
The following cannot be selected:
• Groups without a remote control switch
• Groups in which the representative remote control switch group is not a standard unit supporting H-LINK II (setting
temperature range is from 19 to 30 degrees for cooling, and from 17 to 30 degrees for heating).
(2)
3 Tap “ ” or “ ” to set the minimum setting temperature for cooling and/or the maximum temperature for heating.
4 Tap “Setting completed” to conrm the content of settings and to return to the selection screen.
5 Tap “Cancel” to discard the displayed settings and return to the selection screen.
(3)
(5)(4)
5 Centralised remote controls
PSC-A32MN
TCGB0106 rev.0 - 12/2014
338
To Next Page
Loading...
Need help?
General
