HP 1910 User Manual

98
Figure 78 Loopback test page
2. Select External or Internal for loopback test type.
3. Select an Ethernet interface from the chassis front panel.
4. Click Test.
After the test is complete, the system displays the loopback test result, as shown in Figure 79.
Figure 79 Loopback test result

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24