HP 1910 - Removing ARP Entries; Configuring Gratuitous ARP

267
3. Configure the static ARP entry as described in Table 81.
4. Click Apply.
Table 81 Configuration items
Item Descri
p
tion
IP Address Enter an IP address for the static ARP entry.
MAC Address Enter a MAC address for the static ARP entry.
Advanced
Options
VLAN ID
Enter a VLAN ID and specify a port for the static ARP entry.
IMPORTANT:
The VLAN ID must be the ID of the VLAN that has already been created, and the port
must belong to the VLAN. The corresponding VLAN interface must have been created.
Port
Removing ARP entries
1. From the navigation tree, select Network > ARP Management.
The ARP Table page appears, as shown in Figure 231.
2. Remov
e ARP entries:
{ To remove specific ARP entries, select the boxes of target ARP entries, and click Del Selected.
{ To remove all static and dynamic ARP entries, click Delete Static and Dynamic.
{ To remove all static ARP entries, click Delete Static.
{ To remove all dynamic ARP entries, click Delete Dynamic.
Configuring gratuitous ARP
1. From the navigation tree, select Network > ARP Management.
2. Click the Gratuitous ARP tab.
Figure 233 Gratuitous ARP configuration page
3. Configure gratuitous ARP as described in Table 82.
Table 82 Configuration items
Item Descri
p
tion
Disable gratuitous ARP packets
learning function
Disable learning of ARP entries from gratuitous ARP packets.
Gratuitous ARP packet learning is enabled by default.