HP 1910 - Creating an Ipv4 Static Route

303
Field Descri
p
tion
Next Hop Next hop IP address of the IPv4 route.
Interface
Output interface of the IPv4 route. Packets destined for the specified
network segment will be sent out of the interface.
Creating an IPv4 static route
1. Select Network > IPv4 Routing from the navigation tree.
2. Click the Create tab.
The page for configuring an IPv4 static route appears.
Figure 269 Creating an IPv4 static route
3. Create an IPv4 static route as described in Table 91.
4. Click Apply.
Table 91 Configuration items
Item Descri
p
tion
Destination IP Address Enter the destination host or network IP address in dotted decimal notation.
Mask
Enter the mask of the destination IP address.
You can enter a mask length or a mask in dotted decimal notation.