HP 1910 User Manual

161
Figure 150 Assigning GigabitEthernet 1/0/1 to VLAN 2 and to VLANs 6 through 50 as a
tagged member
Configuring Switch B
Configure Switch B in the same way Switch A is configured.
Configuration guidelines
Follow these guidelines when you configure VLANs:
• As the default VLAN, VLAN 1 can be neither created nor removed manually.
• You cannot manually create or remove VLANs reserved for special purposes.
• Dynamic VLANs cannot be removed on the page for removing VLANs.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24