HP 1910 User Manual

62
Configuring system time
Overview
You must configure a correct system time so that the device can operate correctly with other devices. The
system time module allows you to display and set the device system time and system zone on the web
interface.
You can set the system time through manual configuration or network time protocol (NTP) automatic
synchronization.
Defined in RFC 1305, the NTP synchronizes timekeeping among distributed time servers and clients. NTP
can keep consistent timekeeping among all clock-dependent devices within the network and ensure a
high clock precision so that the devices can provide diverse applications based on consistent time.
Displaying the current system time
To view the current system date and time, select Device > System Time from the navigation tree to enter
the System Time page.
Figure 48 System time configuration page
Manually configuring the system time
1. Select Device > System Time from the navigation tree.
The page for configuration the system time appears.
2. Click the System Time Configuration text to open a calendar.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24