HP 1910 User Manual

224
Setting LACP priority
1. From the navigation tree, select Network > LACP.
2. Click Setup to enter the page shown in Figure 196.
Figure 196 The Setup tab
3. In the Set LACP enabled port(s) parameters area, set the port priority, and select the ports in the
chassis front panel.
4. Click Apply in the area.
Table 67 Configuration items
Item Descri
p
tion
Port Priority Set a port LACP priority.
Select port(s) to
apply Port Priority
Choose the ports where the port LACP priority you set will apply on the chassis front panel.
(You can set LACP priority on both LACP-enabled ports and LACP-disabled ports.)
5. In the Set global LACP parameters area, set the system priority.
6. Click Apply in the area.
Displaying LACP-enabled port information
1. From the navigation tree, select Network > LACP.
The Summary tab is displayed by default, as shown in Figure 197. The u
pper part of the page
displays a list of all LACP-enabled ports on the device and information about them. Table 68
describes the
fields.
2. Select a port on the port list.
3. Click View Details.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24