HP 1910 - Configuring 802.1 X on a Port; Configuration Guidelines; Configuration Procedure

360
Table 104 Configuration items
Item Descri
p
tion
Quiet
Specify whether to enable the quiet timer.
The quiet timer enables the network access device to wait a period of time
defined by the Quiet Period option before it can process any authentication
request from a client that has failed an 802.1X authentication.
Quiet Period Set the value of the quiet timer.
Retry Times
Set the maximum number of authentication request attempts.
The network access device retransmits an authentication request if it does not
receive a response to the request it has sent to the client within a period of time
(specified by using the TX Period option or the Supplicant Timeout Time
option). The network access device stops retransmitting the request, if it has
made the maximum number of request transmission attempts but still received
no response.
TX-Period Set the username request timeout timer.
Handshake Period
Set the handshake timer.
For information about how to enable the online user handshake function, see
"Configuring 802.1X on a port."
Re-Authentication Period
Set the periodic online user re-authentication timer.
For information about how to enable periodic online user re-authentication on
a port, see "Configuring 802.1X on a port."
Supplicant Timeout Time Set the client timeout timer.
Server Timeout Time Set the server timeout timer.
NOTE:
You can set the client timeout timer to a high value in a low-performance network, and adjust the server
timeout timer to adapt to the performance of different authentication servers. In most cases, the default
settings are sufficient.
Configuring 802.1X on a port
Configuration guidelines
When you configure 802.1X on a port, follow these restrictions and guidelines:
• 802.1X configuration on a specific port can take effect only after global 802.1X and port-specific
802.1X are enabled.
• If the PVID of a port is a voice VLAN, the 802.1X function cannot take effect on the port.
• 802.1X is mutually exclusive with link aggregation and service loopback group configuration on a
port.
Configuration procedure
1. From the navigation tree, select Authentication > 802.1X.