121
Configuring energy saving
Energy saving enables a port to operate at the lowest transmission speed, disable PoE, or go down
during a specific time range on certain days of a week. The port resumes working normally when the
effective time period ends.
Configuring energy saving on a port
1. Select Device > Energy Saving from the navigation tree to enter the energy saving configuration
page.
2. Click a port.
Figure 104 Energy saving configuration page
3. Configure an energy saving policy for the port as described in Table 30.
4. Click Apply.
Table 30 Configuration items
Item Descri
Time Range Set the time period when the port is in the state of energy saving.
IMPORTANT:
• Up to five energy saving policies with different time ranges can be configured on a
port.
• Specify the start time and end time in units of 5 minutes, such as 08:05 to 10:15.
Otherwise, the start time is postponed and the end time is brought forward so that
they meet the requirements. For example, if you set the time range to 08:08 to
10:12, the effective time range is 08:10 to 10:10.
Sun through Sat
PoE Disabled Disable PoE on the port.
To Next Page
Loading...
Need help?
General
