HP 1910 User Manual

326
Configuring and displaying clients' IP-to-MAC
bindings
1. Select Network > DHCP from the navigation tree to enter the DHCP Relay page shown in Figure
289.
2. In the User Information area, click User Information to view static and dynamic bindings.
Figure 292 Displaying clients' IP-to-MAC bindings
3. Click Add to enter the page for creating a static IP-to-MAC binding.
Figure 293 Creating a static IP-to-MAC binding
4. Configure the static IP-to-MAC binding as described in Table 97.
5. Click Apply.
Table 97 Configuration items
Item Descri
p
tion
IP Address Enter the IP address of a DHCP client.
MAC Address Enter the MAC address of the DHCP client.
Interface Name
Select the Layer 3 interface connected with the DHCP client.
IMPORTANT:
The interface of a static binding entry must be configured as a DHCP relay agent;
otherwise, address entry conflicts might occur.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24