HP 1910 - Authorized IP Configuration Example; Network Requirements; Configuration Procedure

470
Authorized IP configuration example
Network requirements
In Figure 454, configure Switch to deny Telnet and HTTP requests from Host A, and permit Telnet and
HTTP requests from Host B.
Figure 454 Network diagram
Configuration procedure
1. Create an ACL:
a. Select QoS > ACL IPv4 from the navigation tree.
b. Click the Create tab.
c. Enter 2001 for ACL Number.
d. Click Apply.
Figure 455 Creating an ACL
2. Configure an ACL rule to permit Host B:
a. Click the Basic Setup tab
The page for configuring an ACL rule appears.