HP 1910 - Modifying a VLAN Interface

164
Item Descri
p
tion
Configure
IPv6 Link
Local
Address
Auto
Configure the way in which the VLAN interface obtains an IPv6
link-local address.
Select the Auto or Manual option:
• Auto—The device automatically assigns a link-local address for
the VLAN interface based on the link-local address prefix
(FE80::/64) and the link-layer address of the VLAN interface.
• Manual—Requires manual assignment.
These items
are available
after you
select the
Configure
IPv6 Link
Local
Address box.
Manual
IPv6
Address
Configure an IPv6 link-local address for the VLAN interface.
This field is available after you select the Manual option. The prefix of
the IPv6 link-local address you enter must be FE80::/64.
Modifying a VLAN interface
By modifying a VLAN interface, you can assign an IPv4 address, an IPv6 link-local address, and an IPv6
site-local address, or global unicast address to the VLAN interface, and shut down or bring up the VLAN
interface.
To modify a VLAN interface:
1. Select Network > VLAN Interface from the navigation tree.
2. Click the Modify tab to enter the page for modifying a VLAN interface.
Figure 152 Modifying a VLAN interface
3. Modify a VLAN interface as described in Table 44.
4. Click Apply.