HP 1910 User Manual

469
Configuring authorized IP
The authorized IP function associates the HTTP or Telnet service with an ACL to filter the requests of clients.
Only the clients that pass the ACL filtering can access the device.
Configuration procedure
1. Select Security > Authorized IP from the navigation tree.
2. Click the Setup tab to enter the authorized IP configuration page.
Figure 453 Authorized IP configuration page
3. Configure authorized IP as described in Table 128.
4. Click Apply.
Table 128 Configuration items
Item Descri
p
tion
Telnet
IPv4 ACL
Associate the Telnet service with an IPv4 ACL.
You can configure the IPv4 ACL to be selected by selecting QoS > ACL IPv4.
IPv6 ACL
Associate the Telnet service with an IPv6 ACL.
You can configure the IPv6 ACL to be selected by selecting QoS > ACL IPv6.
Web
(HTTP)
IPv4 ACL
Associate the HTTP service with an IPv4 ACL.
You can configure the IPv4 ACL to be selected by selecting QoS > ACL IPv4.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24