HP 1910 User Manual

1
Overview
The HP 1910 Switch Series can be configured through the command line interface (CLI), Web interface,
and SNMP/MIB. These configuration methods are suitable for different application scenarios.
• The Web interface supports all 1910 Switch Series configurations.
• The CLI provides configuration commands to facilitate your operation. To perform other
configurations not supported by the CLI, use the Web interface.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24