HP 1910 - Displaying the System Resource State; Displaying Recent System Logs; Setting the Refresh Period

54
Item Descri
p
tion
Contact Information
Display the contact information, which you can configure on
the page you enter by selecting Device > SNMP
> Setup.
SerialNum Display the serial number of the device.
Software Version Display the software version of the device.
Hardware Version Display the hardware version of the device.
Bootrom Version Display the Boot ROM version of the device.
Running Time Display the system up time.
Displaying the system resource state
The System Resource State area displays the most recent CPU usage, memory usage, and temperature
status.
The temperature status is represent by the color of its status bar as follows:
• Blue—Normal.
• Yellow—Warning.
• Red—Alarm.
Displaying recent system logs
Table 8 Field description
Field Descri
p
tion
Time Display the time when the system logs were generated.
Level Display the severity of the system logs.
Description Display the description of the system logs.
The System Information page displays up to five the most recent system logs about the login and logout
events.
To display more system logs, click More to enter the Log List page. You can also enter this page by
selecting Device > Syslog. For more information, see "Configuring syslog."
Setting the refresh period
To set the interval for refreshing system information, select one of the following options from the Refresh
Period list:
• If you select a certain period, the system refreshes system information at the specified interval.
• If you select Manual, the system refreshes system information only when you click the Refresh button.