HP 1910 User Manual

120
Figure 102 Configuring an alarm group
Verifying the configuration
After the above configuration, when the alarm event is triggered, you can view the log information about
event 1 on the web interface.
1. Select Device > RMON from the navigation tree.
2. Click the Log tab.
The log page appears. The log in this example indicates that event 1 generated one log, which
was triggered because the alarm value (22050) exceeded the rising threshold (1000). The
sampling type is absolute.
Figure 103 Log tab

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24