HP 1910 User Manual

119
Figure 100 Configuring an event group
Figure 101 Displaying the index of a event entry
4. Configure an alarm group to sample received bytes on GigabitEthernet 1/0/1. When the
received bytes exceed the rising or falling threshold, logging is enabled:
a. Click the Alarm tab.
b. Click Add.
The page in Figure 102 ap
pears.
c. Select Number of Received Bytes from the Static Item list, select GigabitEthernet1/0/1 from the
Interface Name list, enter 10 in the Interval field, select Delta from the Simple Type list, enter
user1 in the Owner field, enter 1000 in the Rising Threshold field, select 1 from the Rising Event
list, enter 100 in the Falling Threshold field, select 1 from the Falling Event list, and click Apply.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24