HP 1910 User Manual

223
2. Choose an aggregate interface from the list.
The list on the lower part of the page displays the detailed information about the member ports of
the link aggregation group.
Figure 195 Displaying information of an aggregate interface
Table 66 Field description
Field Descri
p
tion
Aggregation interface
Type and ID of the aggregate interface.
Bridge-Aggregation indicates a Layer 2 aggregate interface.
Link Type Type of the aggregate interface: static or dynamic.
Partner ID ID of the remote device, including its LACP priority and MAC address.
Selected Ports
Number of Selected ports in each link aggregation group (Only Selected ports
can send and receive user data).
Standby Ports
Number of Unselected ports in each link aggregation group (Unselected ports
cannot send or receive user data).
Member Port
A member port of the link aggregation group corresponding to the selected
aggregate interface.
State Aggregation state of a member port: Selected or Unselected.
Reason for being Unselected
Reason why the state of a member port is Unselected. For a Selected port, this
field displays two hyphens (--).

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24