HP 1910 User Manual

126
Figure 107 Setup tab
2. Configure SNMP settings on the upper part of the page as described in Table 33.
3. Click Apply.
Table 33 Configuration items
Item Descri
p
tion
SNMP Specify to enable or disable SNMP agent.
Local Engine ID
Configure the local engine ID.
Validity of a user depends on the engine ID of the SNMP agent. If the engine ID
when the user is created is not identical to the current engine ID, the user is
invalid.
Maximum Packet Size Configure the maximum size of an SNMP packet that the agent can receive/send.
Contact
Set a character string to describe the contact information for system maintenance.
If the device is faulty, the maintainer can contact the manufacture factory
according to the contact information of the device.
Location Set a character string to describe the physical location of the device.
SNMP Version Set the SNMP version run by the system.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24