HP 1910 User Manual

229
aggregation, make sure that the peer ports of the ports aggregated at one end are also aggregated.
The two ends can automatically negotiate the aggregation state of each member port.
• Removing a Layer 2 aggregate interface also removes its aggregation group and causes all
member ports to leave the aggregation group.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24