HP 1910 User Manual

258
Figure 224 Configuring ports
3. Configure the voice VLAN function on the two ports:
a. Select Network > Voice VLAN from the navigation tree.
b. Click the Port Setup tab to enter the page for configuring the voice VLAN function on ports.
c. Select Auto in the Voice VLAN port mode list, select Enable in the Voice VLAN port state list,
enter the voice VLAN ID 2, and select port GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2
from the chassis front panel.
d. Click Apply.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24