HP 1910 User Manual

340
Item Descri
p
tion
HTTP
Enable HTTP
service
Enable or disable the HTTP service.
The HTTP service is enabled by default.
Port Number
Set the port number for HTTP service.
You can view this configuration item by clicking the expanding button in
front of HTTP.
IMPORTANT:
When you modify a port, make sure that the port is not used by any other
service.
ACL
Associate the HTTP service with an ACL. Only the clients that pass the ACL
filtering are permitted to use the HTTP service.
You can view this configuration item by clicking the expanding button in
front of HTTP.
HTTPS
Enable HTTPS
service
Enable or disable the HTTPS service.
The HTTPS service is disabled by default.
Port Number
Set the port number for the HTTPS service.
You can view this configuration item by clicking the expanding button in
front of HTTPS.
IMPORTANT:
When you modify a port, make sure that the port is not used by any other
service.
ACL
Associate the HTTPS service with an ACL. Only the clients that pass the ACL
filtering are permitted to use the HTTPS service.
You can view this configuration item by clicking the expanding button in
front of HTTPS.
PKI Domain
Select a PKI domain for the HTTPS service from the PKI Domain dropdown
list.
You can configure the PKI domains available in the dropdown list in
Authentication > PKI. For more information, see "Configuring PKI."

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24