446
Figure 429 Local user configuration page
3. Configure the local user as described in Table 121.
4. Click Apply.
Table 121 Configuration items
Item Descri
Username Specify a name for the local user.
Password
Confirm
Specify and confirm the password of the local user. The settings of these two fields must
be the same.
IMPORTANT:
Do not specify a password starting with spaces, because the spaces will be ignored.
Group
Select a user group for the local user.
For information about user group configuration, see "Configuring a user group."
Password Encryption Select a password encryption method: Reversible or Irreversible.
Service-type
Select the service types for the local user to use: FTP, Telnet, Portal, LAN-Access, SSH,
or WEB. The LAN-Access service primarily represents Ethernet users, such as 802.1X
users.
The switch series does not support PPP.
IMPORTANT:
If you do not specify any service type for a user who uses local authentication, the user
cannot pass authentication.
Expire-time
Specify an expiration time for the local user, in the HH:MM:SS-YYYY/MM/DD format.
When the NAS authenticates a local user with the expiration time argument
configured, it checks whether the expiration time has elapsed. If the expiration time is
not expired, the NAS permits the user to log in.
Level
Select an authorization level for the local user: Visitor, Monitor, Configure, or
Management, in ascending order of priority.
This option takes effect on only FTP, Telnet, and SSH users.
To Next Page
Loading...
