HP 1910 User Manual

39
1. On the system parameter configuration page, click Next.
Figure 26 Management IP address configuration page
2. Configure the parameters as described in Table 4.
Table 4 Configuration items
Item Descri
p
tion
Select VLAN Interface
Select a VLAN interface.
Available VLAN interfaces are those configured in the page that you enter by selecting
Network > VLAN Interface and selecting the Create tab.
The IP address of a VLAN interface can be used as the management IP address to
access the device. You can configure a VLAN interface and its IP address in the page
that you enter by selecting Network > VLAN Interface. For more information, see
"Configuring VLAN interfaces."
Admin status
Enable or disable the VLAN interface.
When errors occurred in the VLAN interface, disable the interface and then enable the
port to bring the port to operate correctly.
By default, the VLAN interface is down if no Ethernet ports in the VLAN is up. The
VLAN is in the up state if one or more ports in the VLAN are up.
IMPORTANT:
Disabling or enabling the VLAN interface does not affect the status of the Ethernet ports
in the VLAN. That is, the port status does not change with the VLAN interface status.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24