HP 1910 User Manual

83
Figure 65 Configuring the rate of GigabitEthernet 1/0/4
2. Batch configure the autonegotiation rate range on GigabitEthernet 1/0/1, GigabitEthernet
1/0/2, and GigabitEthernet 1/0/3 as 100 Mbps:
a. On the Setup tab, select Auto 100 from the Speed list, as shown in Figure 66.
b. Selec
t 1, 2, and 3 on the chassis front panel.
1, 2, and 3 represent ports GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and
GigabitEthernet 1/0/3.
c. Click Apply.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24