HP 5800 Series User Manual

146
View
Any view
Default level
1: Monitor level
Parameters
destination address: Specifies a destination IP address to display only the tunnels with the specified
destination IP address.
lsr-id: Specifies the LSR ID of the ingress node, in dotted decimal notation.
lsp-id: Specifies the LSP ID, ranging from 1 to 65,535.
lsr-role: Displays tunnels by LSR role (ingress, transit, egress, or remote).
all: Displays all tunnels.
egress: Displays tunnels created taking the current device as the egress.
ingress: Displays tunnels created taking the current device as the ingress .
remote: Displays tunnels created taking the current device as the egress or a transit node.
transit: Displays tunnels created taking the current device as a transit node.
name name: Displays the tunnel with a particular name. This could be a string of 1 to 63 characters
configured as interface description or the interface name if no interface description is configured. The
tunnel name should be signaled to all hops.
incoming-interface: Displays all tunnels that use the interface identified by the interface-type interface-
number parameters as the incoming interface.
outgoing-interface: Displays all tunnels that use the interface identified by the interface-type interface-
number parameters as the outgoing interface.
interface: Displays all tunnels that use the interface identified by the interface-type interface-number
parameters as the incoming or outgoing interface.
interface-type interface-number: Specifies an interface by its type and number.
verbose: Displays detailed information.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 256 characters.
Examples
# Display information about MPLS TE tunnels. (The output may vary by signaling protocol.)
<Sysname> display mpls te tunnel
LSP-Id Destination In/Out-If Name
1.1.1.9:1024 3.3.3.9 -/Vlan3 Tunnel1
1.1.1.9:2048 3.3.3.9 -/Vlan4 Tunnel2

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)