348
Connect-interface has been configured
Peer Preferred Value: 0
BFD: Enabled
Routing policy configured:
No routing policy is configured
Table 136 Command output
Field Description
Peer IP address of the peer.
Local IP address of the local router.
Type BGP type.
BGP version Version of BGP that the peer runs.
remote router ID Router ID of the remote router.
BGP current state Current state of the BGP session.
Up for Duration since the peer is established.
BGP current event Current event of the BGP session.
BGP last state
State that the BGP session was in before transitioning to the current
state.
Port Local and remote ports of the BGP session.
Configured
Settings of the local timers, including the active hold interval and
keepalive interval.
Received Received active hold interval.
Negotiated Negotiated active hold interval.
Peer optional capabilities Optional capabilities of the peer.
Peer support bgp multi-protocol
extended
The peer supports multiprotocol extension.
Peer support bgp route refresh
capability
The peer supports route refreshing.
Address family IPv4 Unicast IPv4 unicast family capability.
Address family VPNv6 VPNv6 address family capability.
Received
Total number of received messages and the number of received update
messages.
Sent
Total number of sent messages and the number of sent update
messages.
Maximum allowed prefix number Maximum number of routes that the VPN instance supports.
Threshold
Threshold for warning. When the percentage of the number of the
received route prefixes to the maximum number of routes supported
reaches this value, the device generates a prompt.
Minimum time between
advertisement runs
Minimum interval between route advertisements.
Optional capabilities Local optional capabilities.
To Next Page
Loading...
Need help?
General
