HP 83480A User Manual

Messages
Waveform Menu
Reinstall the plug-in.
Finger tighten the knurled screw on the front panel of the plug-in.
If these actions do not solve the problem, there must be a hardware problem
in the mainframe or plug-in. Call Hewlett-Packard for service.
Incompatible setup
It is possible that due to a system rmware change, a previously saved setup
may become incompatible.
Incompatible
signal
An
attempt
was
made
to
load
a signal
format that
is incompatible
with the
instrument
from
disk.
Low
battery
voltage
detected:
Service
is
required
Change
the
battery
as
soon
as
this
message
is
displayed.
Cal
factors
and
data
may
be lost
when
the
power
is
cycled,
and
the
instrument
may
not
function
correctly
. When
Hewlett-P
ackard
service
replaces
the
battery
,
a
revised
boot
ROM
may be
installed.
Mask
test align
failed
The
mask
test
align
algorithm
was
not
able to
detect a
signal compatible
with
the
installed
mask.
This
can
occur
when
there are
not enough
points on
an
edge or when the required edges are not present. Adjust the timebase to
place the required edges on the display.
Measurement cannot be performed on the selected waveform
The
measurement is
not
dened
for
this
waveform
type
,
and
cannot
be
made.
F
or example
,
the
rise
time
of
an
A
versus
B
waveform
is not
dened.
Memory error occurred in plug-in ?: Try reinstalling plug-in
The checksum or contents of the plug-in's memory is incorrect. The \?"
indicates which plug-in has the error
. Check the following:
Reinstall the plug-in.
12-4

HP 83480A Specifications

General

Brand	HP
Model	83480A
Category	Measuring Instruments
Language	English