96
802.1X configuration commands
display dot1x
Syntax
display dot1x [ sessions | statistics ] [ interface interface-list ] [ | { begin | exclude | include } regular-
expression ]
View
Any view
Default level
1: Monitor level
Parameters
sessions: Displays 802.1X session information.
statistics: Displays 802.1X statistics.
interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to interface-
type interface-number ] } & <1-10>, where interface-type represents the port type, interface-number
represents the port number, and & <1-10> means that you can provide up to 10 ports or port ranges. The
start port number must be smaller than the end number and the two ports must be the same type.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use the display dot1x command to display information about 802.1X.
If you specify neither the sessions keyword nor the statistics keyword, the command displays all
information about 802.1X, including session information, statistics, and configurations.
Related commands: reset dot1x statistics, dot1x, dot1x retry, dot1x max-user, dot1x port-control, dot1x
port-method, and dot1x timer.
Examples
# Display all information about 802.1X.
<Sysname> display dot1x
Equipment 802.1X protocol is enabled
CHAP authentication is enabled
EAD quick deploy is enabled
Configuration: Transmit Period 30 s, Handshake Period 15 s
To Next Page
Loading...
Need help?
General
