EasyManuals Logo

HP A5500 EI User Manual

HP A5500 EI
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #320 background imageLoading...
Page #320 background image
310
Examples
# Configure dynamic IPv4 binding of packet source IP address and MAC address on Layer 2 Ethernet
port GigabitEthernet 1/0/1 to filter packets based on the dynamically generated DHCP snooping entries.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] ip check source ip-address mac-address
# Configure dynamic IPv4 binding of packet source IP address and MAC address on VLAN-interface 100
to filter packets based on the dynamically generated DHCP relay entries.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ip check source ip-address mac-address
# Configure dynamic IPv6 binding of packet source IP address and MAC address on Layer 2 Ethernet
port GigabitEthernet 1/0/1 to filter packets based on the dynamically generated DHCPv6 snooping
entries or ND snooping entries.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] ip check source ipv6 ip-address mac-address
user-bind (Layer 2 Ethernet port view)
Syntax
user-bind [ ipv6 ] { ip-address ip-address | ip-address ip-address mac-address mac-address | mac-
address mac-address } [ vlan vlan-id ]
undo user-bind [ ipv6 ] { ip-address ip-address | ip-address ip-address mac-address mac-address | mac-
address mac-address } [ vlan vlan-id ]
View
Layer 2 Ethernet port view
Default level
2: System level
Parameters
ipv6: Binds an IPv6 address. Without this keyword, an IPv4 address is bound.
ip-address ip-address: Specifies the IP address for the static binding. The IPv4 address can only be a
Class A, Class B, or Class C address and can be neither 127.x.x.x nor 0.0.0.0. The IPv6 address cannot
be all 0s, a multicast address, or a loopback address.
mac-address mac-address: Specifies the MAC address for the static binding in the format H-H-H. The
MAC address cannot be all 0s, all Fs (a broadcast address), or a multicast address.
vlan vlan-id: Specifies the VLAN for the static binding. vlan-id is the ID of the VLAN to be bound, in the
range 1 to 4094. The switch does not support the vlan vlan-id option.
Description
Use the user-bind command to configure a static binding.
Use the undo user-bind command to delete a static binding.
By default, no static binding exists on a port.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP A5500 EI and is the answer not in the manual?

HP A5500 EI Specifications

General IconGeneral
BrandHP
ModelA5500 EI
CategoryNetwork Router
LanguageEnglish

Related product manuals