187
View
Local user view
Default level
2: System level
Parameters
None
Description
Use the password command to set a password for a local user in interactive mode.
Use the undo password command to remove the password for a local user.
Valid characters for a local user password include uppercase letters A to Z, lowercase letters a to z,
numbers 0 to 9, blank space, and these 31 symbols: ~`!@#$%^&*()_+-={}|[]\:‖;’<>,./.
A local user password configured in interactive mode must satisfy the password control requirement. For
example, if the minimum password length is set to 8, the password must contain at least eight characters.
Examples
# Set a password for local user test in interactive mode.
<Sysname> system-view
[Sysname] local-user test
[Sysname-luser-test] password
Password:**********
Confirm :**********
Updating user(s) information, please wait....
password-control aging
Syntax
password-control aging aging-time
undo password-control aging
View
System view, user group view, local user view
Default level
2: System level
Parameters
aging-time: Specifies the password aging time in days, in the range 1 to 365.
Description
Use the password-control aging command to set the password aging time.
Use the undo password-control aging command to restore the default.
By default, the global password aging time is 90 days, the password aging time of a user group equals
the global setting, and the password aging time of a local user equals that of the user group to which the
local user belongs.
To Next Page
Loading...
Need help?
General
