HP A5500 EI User Manual

309
N/A 2002::2 N/A GE1/0/1 Static_IPv6
0002-0002-0022 N/A N/A GE1/0/1 Static_IPv6
Table 49 Output description
Field
Description
Total entries found
Total number of found entries
MAC Address
MAC address of the binding. N/A means that no MAC address is bound in the
entry.
IP Address
IP address of the binding. N/A means that no IP address is bound in the entry.
VLAN
VLAN of the binding. N/A means that no VLAN is bound in the entry.
Interface
Interface of the binding
Type
Type of the binding:
 Static—Static IPv4 binding entry.
 Static_IPv6—Static IPv6 binding entry.
ip check source
Syntax
ip check source [ ipv6 ] { ip-address | ip-address mac-address | mac-address }
undo ip check source [ ipv6 ]
View
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, VLAN interface view
Default level
2: System level
Parameters
ipv6: Configures dynamic IPv6 source guard binding. Without this keyword, the command configures
dynamic IPv4 source guard binding.
ip-address: Binds source IP addresses to the port.
ip-address mac-address: Binds source IP addresses and MAC addresses to the port.
mac-address: Binds source MAC addresses to the port.
Description
Use the ip check source command to configure the dynamic IP source guard binding function on a port.
Use the undo ip check source command to restore the default.
By default, the dynamic IP source guard binding function is disabled.
You cannot configure the dynamic IP source guard binding function on a port in an aggregation group or
a service loopback group.
The dynamic IPv6 source guard binding function can be configured in only Layer 2 Ethernet port view.
Related commands: display ip check source.

HP A5500 EI Specifications

General

Brand	HP
Model	A5500 EI
Category	Network Router
Language	English