HP A5500 EI - User-Profile Enable; User-Profile

182
Field
Description
User profile
User profile name
AuthType
Authentication type of the user profile, which takes one of the
following values:
 DOT1X: 802.1X authentication
 PORTAL: portal authentication
Total user profiles
Total number of user profiles that have been created
Enabled user profiles
Total number of user profiles that have been enabled
user-profile enable
Syntax
user-profile profile-name enable
undo user-profile profile-name enable
View
System view
Default level
2: System level
Parameters
profile-name: Specifies the name of an existing user profile. The name takes a case-sensitive string of 1 to
31 characters. It can only contain English letters, digits, and underlines, and it must start with an English
letter.
Description
Use the user-profile enable command to enable a user profile that has been created. If the user profile
does not exist, the command fails. Only enabled user profiles can be applied to authenticated users.
Use the undo user-profile enable command to disable the specified user profile. Disabling a user profile
logs out users that are using the user profile. To edit or remove the configurations in a user profile, disable
the user profile first.
By default, a created user profile is disabled.
Examples
# Enable user profile a123.
<Sysname> system-view
[Sysname] user-profile a123 enable
user-profile
Syntax
user-profile profile-name
undo user-profile profile-name